Deploy CloudFormation stack

1. Start deployment in AWS CloudFormaton
To deploy the solution in your AWS account, please click on one of the links below:

2. Select parameters
After you have been redirected to the “Quick create stack” page at the AWS CloudFormation console please take the following steps to launch you stack:

  • Leave the default values for Stack name
  • If you have one of the listed LoRaWAN devices, please select it. If your device is not listed, please select the default value “sample_device”.
  • Capabilities (at the bottom of the page):
    • Check I acknowledge that AWS CloudFormation might create IAM resources
    • Check I acknowledge that AWS CloudFormation might create IAM resources with custom names.
    • Check I acknowledge that AWS CloudFormation might require the following capability: CAPABILITY_AUTO_EXPAND

Please click on “Create stack” and wait until the complete stack is created.

AWS Management Console

3. Verify successful stack deployment
It should take about 10 minutes for the stack to complete. Plesse ensure that the main stack and two additional nested stacks have status “CREATE_COMPLETE”. After that please click on the stack name of the main stack.

AWS Management Console

4. Identify the rule name
Please navigate to stack outputs and note the value of the parameter RuleName. This value will be required in the next step to update the AWS IoT for LoRaWAN destination. Please do not close the window yet, values of further outputs (i.e. GrafanaDashboardUrl) will be required in the later steps.

AWS Management Console